Texas roofing code requirements
Updated October 2026 · For roofing contractors
Texas has no single statewide residential code. Inside city limits, the 2012 IRC is the minimum (Tex. Local Gov’t Code §214.212), and most cities have adopted a newer edition with amendments. In unincorporated county areas, new homes in covered counties must meet the IRC as published May 1, 2008 or the edition used in the county seat (§233.153), and counties generally do not permit or inspect re-roofs. Confirm with the city or county where the house is.
- IRC base
- 2012 IRC
- State code
- None statewide
- Note
- 2012 IRC is the floor inside city limits (Tex. Local Gov’t Code §214.212); cities usually adopt 2015–2021 with amendments. Unincorporated county areas follow a narrower rule (§233.153)
Roofing requirements that matter for supplements in Texas
These IRC roofing provisions are the ones that most often turn into supplement items on a replacement. Section numbers are from recent IRC editions and can differ in older ones or in local amendments.
| Item | Section | What it requires |
|---|---|---|
| Install per manufacturer | IRC R905.1 | Roof coverings go on per the manufacturer’s installation instructions, which brings starter, hip and ridge and fastening requirements into the code. |
| Drip edge | IRC R905.2.8.5 | Required at eaves and rakes of shingle roofs under the 2012 IRC. |
| Ice barrier at eaves | IRC R905.1.2 | Required where the local jurisdiction designates a history of ice damming (Table R301.2), from the eave edge to at least 24 inches inside the exterior wall line. |
| Underlayment | IRC R905.1.1 (2018+) | Type, laps and fastening per the code table and the manufacturer. |
| Tear-off and recover limits | IRC R908 | Recent editions require removal down to the deck when replacing, and limit recovering over existing layers. |
| Damaged flashing and vents | IRC R908.5 | Rusted, damaged or deteriorated flashing, vent collars and metal edging aren’t reinstalled. |
| Chimney cricket | IRC R903.2.2 | Required on the upslope side of a chimney more than 30 inches wide, unless covered by flashing. |
| Attic ventilation | IRC R806 | Net free vent area at 1/150 of the attic floor area, or 1/300 when the code’s conditions are met. |
Finding the code for a specific Texas address
Because Texas leaves adoption to local jurisdictions, check the city first, then the county for unincorporated addresses. The building department’s website usually lists the adopted code and amendments. RecountRoof looks this up for you for any U.S. address and flags code items missing from the adjuster estimate, with the section attached.
More on using code in a supplement: roofing code upgrades on insurance claims, drip edge and ice barrier requirements and the roofing supplement checklist.
For city- and county-level permit rules, each cited to its source, see Texas roofing permits on The Roofing Book.
Compiled from state code-adoption summaries, October 2026. This is general information, not legal advice; confirm the adopted code with the local building department before relying on it.
Other states
- Alabama
- Alaska
- Arizona
- Arkansas
- California
- Colorado
- Connecticut
- Delaware
- District of Columbia
- Florida
- Georgia
- Hawaii
- Idaho
- Illinois
- Indiana
- Iowa
- Kansas
- Kentucky
- Louisiana
- Maine
- Maryland
- Massachusetts
- Michigan
- Minnesota
- Mississippi
- Missouri
- Montana
- Nebraska
- Nevada
- New Hampshire
- New Jersey
- New Mexico
- New York
- North Carolina
- North Dakota
- Ohio
- Oklahoma
- Oregon
- Pennsylvania
- Rhode Island
- South Carolina
- South Dakota
- Tennessee
- Utah
- Vermont
- Virginia
- Washington
- West Virginia
- Wisconsin
- Wyoming