Drip Edge and Ice and Water Shield Code Requirements (IRC)
By Steven Dye, roofing contractor and founder of RecountRoof · Updated October 20, 2026 · 5 min read
Drip edge and ice and water barrier are two of the most frequently missed items on roofing insurance estimates. Both are spelled out in the International Residential Code, which makes them some of the easiest supplement items to support, as long as you cite the edition your jurisdiction actually adopted.
Drip edge: IRC R905.2.8.5
Starting with the 2012 IRC, drip edge is required at the eaves and rake edges of asphalt shingle roofs. In current editions the section also sets how it goes on:
- Adjacent pieces overlap at least 2 inches.
- The drip edge extends at least 1/4 inch below the roof sheathing and at least 2 inches back onto the roof deck.
- It is fastened to the sheathing at no more than 12 inches on center.
- At the eaves, underlayment goes over the drip edge; at the rakes, the drip edge goes over the underlayment.
Quantity it from the eave and rake linear feet on the measurement report, not from the perimeter on the estimate. If the jurisdiction is still on an edition older than 2012, cite the shingle manufacturer’s instructions instead, since many require or recommend drip edge.
Ice barrier: IRC R905.1.2
In recent IRC editions, an ice barrier is required at the eaves in areas where there has been a history of ice forming along the eaves and backing up water. The jurisdiction designates this in its climate and design criteria table (Table R301.2), so the same edition can require it in one county and not the next.
Where it applies, the barrier is either at least two layers of underlayment cemented together or a self-adhering polymer-modified bitumen sheet, extending from the lowest edge of the roof to at least 24 inches inside the exterior wall line of the building.
On wide overhangs, 24 inches inside the wall line can take more than one course of a 36-inch roll. Check the overhang depth in the photos and quantify it.
Using these in a supplement
- Confirm the jurisdiction’s adopted edition and whether it requires ice barrier. Start with your state’s code status.
- Pull eave and rake linear feet from the measurement report.
- For ice barrier, calculate the courses needed from the overhang and the 24-inch rule.
- Cite the section and edition, and attach the code page.
RecountRoof does all four automatically for any U.S. address. Try your first claim free.
This guide is general information for contractors, not legal or insurance advice. Code requirements vary by jurisdiction and edition; confirm with your local building department.