Roofing Waste Factor on Insurance Estimates: How to Get It Right

By Steven Dye, roofing contractor and founder of RecountRoof · Updated October 20, 2026 · 5 min read

Waste is the extra shingle material needed beyond the measured roof area, for cuts at hips, valleys, rakes and penetrations. On a 30-square roof, the difference between 10% and 15% waste is a square and a half of shingles, plus the labor to install them. It is one of the most common gaps between the adjuster’s number and the real material order.

Why the numbers differ

  • Roof shape. A simple gable cuts very little. Hips, valleys, dormers and multiple facets cut a lot more.
  • What is counted separately. Starter and ridge cap are usually separate line items; field-shingle waste shouldn’t be cut because those exist.
  • Rounding. Shingles are sold by the bundle, and a supplier won’t sell you 0.4 of a square.
  • Defaults. Estimating software lets the adjuster choose the waste, and a default may not fit this roof.

How to support your waste factor

  1. Use a third-party measurement report. EagleView, Hover and similar reports include a suggested-waste table based on the actual roof geometry.
  2. Point to the roof’s complexity: number of facets, hip and valley linear feet.
  3. Show the material math: measured squares, waste, bundles to order.
  4. Keep the waste on field shingles separate from starter and ridge cap quantities.

RecountRoof compares the waste on the adjuster estimate to the roof geometry in your measurement report and shows the bundle math in the supplement. See how it works.

This guide is general information for contractors, not legal or insurance advice. Code requirements vary by jurisdiction and edition; confirm with your local building department.

Related guides